Operators of large trucks sometimes do not accurately measure the height of the vehicle or the extra height of the load that they are carrying. When they drive these trucks under a bridge or overpass that has a lower maximum height requirement, these trucks either strike the overpass or, in some cases, the vehicle becomes lodged beneath the overpass.
Excessive traffic congestion and the financial burden of removing lodged trucks and repairing overpasses is a good incentive to apply a relatively simple and inexpensive means of warning drivers if the load that they carry exceeds the maximum height for a bridge or overpass.
Purchase a set of industrial photoelectric sensors that use an amplifier with an internal manual relay. These photoelectric sensors should be positioned in an opposed-mode configuration (or through-beam) so that the transmitting eye is located on one side of the lane and the receiver is on the opposing side. The photo eyes should face one another so that the infrared beam projects across the roadway. The infrared beam should be positioned so that it is horizontal to the road surface and at a height that is just below the maximum allowable vehicle height of the overpass. When the beam is broken by a vehicle or by cargo, it will trigger a signal from the photoelectric amplifier. These photoelectric sensors should be located far enough from the overpass, that they will detect the over-sized vehicle in time to warn the driver to exit the roadway.
Connect the relay from the photoelectric amplifier to a set of flashing lights and use the proper signage to alert the driver and provide them with simple instructions, for example, "WARNING MAXIMUM HEIGHT EXCEEDED - TAKE EXIT WHEN LIGHTS ARE FLASHING!" Though, this solution is a simple one and very inexpensive, the benefits will be quickly realized.
Related articles
How to Troubleshoot Photoelectric Sensors
How to Detect Visitors in a Driveway Using Infrared Photoelectric Sensors
No comments:
Post a Comment